Sparse-Mode Routing Protocols - Dynamically Finding RPs and Using Redundant RPs - Dynamically Finding the RP Using BSR
3 important questions on Sparse-Mode Routing Protocols - Dynamically Finding RPs and Using Redundant RPs - Dynamically Finding the RP Using BSR
What is the difference between auto-rp and bsr?
-BSR router does not pick best RP for each multicast group, but send all group-to-RP mapping information
-PIM routers pick best RP for each multicast group by running the same has algorithm (on the information in the bootstrap message).
-PIM routers pick best RP for each multicast group by running the same has algorithm (on the information in the bootstrap message).
If two BSR are configured, which BSR will win? What happens if a preferred BSR fails?
-Highest-priority BSR wins
-If a tie highest BSR IP address wins
Redundant BSR can take over
-If a tie highest BSR IP address wins
Redundant BSR can take over
What is the command to configure a router as a candidate RP?
(config)#ip pim rp-candidate loopback X
Try our study magic for free
a PDF, study it super fast
- No sign up, email or credit card needed!
- AI makes unlimited flashcards
- Get unlimited quizzes and tests
- Ask AI anything
Create a notebook
- No sign up, email or credit card needed!
- Have and keep perfect overview
- Make flashcards, notes and mind maps
- Review, test and score!
The question on the page originate from the summary of the following study material:
- A unique study and practice tool
- Never study anything twice again
- Get the grades you hope for
- 100% sure, 100% understanding
Remember faster, study better. Scientifically proven.
