Understanding Wireless Roaming and Location Services - Roaming Between Centralized Controllers

4 important questions on Understanding Wireless Roaming and Location Services - Roaming Between Centralized Controllers

What is it called when a client roams between two APs which are connected to different controllers?

Intercontroller roaming
Report

What is a Layer 2 intercontroller roam?

It is when a client roams between two APs connected to different controllers (intercontroller) but stays on the same vlan/subnet (Layer 2) and can keep it's current IP address.
Making roaming very fast (Less than 20 ms)
Report

What is a Layer 3 intercontroller roam?

It is when a client roams to a different subnet on an AP that is connected to a different controller.
Normally the client would need a new IP in the changed subnet. However Cisco controllers contact each other during the roam and create a tunnel between them. The client can then contact the original controller or the Anchor Controller through the new controller or the Foreign Controller, keeping it's original IP address.
Report

What configuration on controllers is needed to facilitate intercontroller roaming?

They need to be part of the same Mobility Group.
Report

The question on the page originate from the summary of the following study material:

  • A unique study and practice tool
  • Never study anything twice again
  • Get the grades you hope for
  • 100% sure, 100% understanding
Remember faster, study better. Scientifically proven.
Trustpilot Logo
  • Higher grades + faster learning
  • Never study anything twice
  • 100% sure, 100% understanding
Discover Study Smart